Curing Curve
The actual curing time may increase due to excessive air humidity or liquid addition ratio
BONDABLE MATERIAL
Other materials include PP, off-road bike fairing etc ，can NOT
be bonded
Remove the STD fairing and turn to the back. Most of these will be marked with material on the back. It can be judged if the fairing is bondable material or not.
Usage tips
Pick up adhesive with the tip of the needle after liquid & powder mixed , and drop the mixed adhesive on the repair area, be sure to squeeze out a little liquid and let the adhesive "just drop". This is Just the right ratio.Do not add too much liquid, otherwise it will make the curing time longer or the strength is insufficient.
When dropping the liquid onto the powder, be sure not to let the mixed adhesive touch the cup, otherwise the adhesive will not be able to pick up with the needle, and keep the powder in the cup over half at least
Keep the liquid in the needle bottle at least over half. If it is less than half, even if the bottle is not pressed under the condition of the needle down, the liquid will flow out from the hole due to the pressure, but as long as it is more than half This does not happen.
When the adhesive on the needle tip is still soft after used, wipe it with a clean cloth or tissue paper, and do not let the mixture flow to the opening hole in the middle of the needle body, then the needle can be used repeatedly.
